[elektro] USB licensz?

[Bali Zoltan]

Storno. Rossz soron nyomtam a választ.
Bocs.

Üdv.  Zoli

2013. 03. 09. 8:06 keltezéssel, Bali Zoltan írta:
> Hali!
>
> Milyen OS környezet ?
>
> Amikor nemrég PCI IO bővitő kártyát kerestem
> a következőt találtam az alábbi linken.
>
> A0009:     It is not possible to manually change IRQ setting of all PCI
> devices in any operating systems because the IRQ used by the device is
> assigned by the PCI system and cannot be changed. Usually the only way
> to change the IRQ of a PCI device is to move it to a different PCI slot.
> Each slot is usually assigned a different IRQ, although this is not
> always true. Each system may handle the assignment of IRQs differently.
> Q0010:     Is it possible to remap the I/O addresses of MCS98xx
> Parallel/Serial ports to Legacy I/O address values?
> A0010:     In order to be compatible with some legacy software, some
> users might need to remap the assigned I/O addresses of MCS98xx
> Parallel/Serial ports to Legacy (ISA type) I/O address (such as 378h,
> 3F8h, etc.). It is possible on DOS and Windows 95/98/ME operating
> systems but impossible on Windows NT/2000/XP/Vista/7/8 operating systems
> because the Remap I/O Address feature is only supported on DOS and
> Windows 95/98/ME operating systems but is not supported on Windows
> NT/2000/XP/Vista/7/8 operating systems. As the newer Windows systems
> maintain a much tighter control over the I/O devices and prevent any
> Re-Mapping I/O Address operation at device driver level. When the
> Re-Mapping I/O Address is not permitted, the device must use the I/O
> Addresses assigned by the PCI system at Boot-Up. If the software
> application expects the Parallel/Serial ports to use Legacy I/O address
> resources, it will not be possible to make it work with the
> Parallel/Serial ports of PCI based devices on Windows
> NT/2000/XP/Vista/7/8 platforms. On DOS platform, MCS98xx can remap the
> I/O addresses of the Parallel/Serial ports to desired values by running
> MCS98xx DOS utility. However, on Windows 95/98/ME platforms, you can
> only remap the I/O addresses of the Serial ports (but not Parallel port).
>
> <http://www.asix.com.tw/faq.php?op=faqdetail&PItemID=126&FaqNoID=#517>
>
> Tehát, ha jól olvasom, max. DOS-nál lehet remap-elni az LPT-t,
> ezeknél az MCS chip-eknél.
>
> Üdv.  Zoli
>
>
> 2013. 03. 08. 18:26 keltezéssel, Pipi írta:
>    
>> 2013.03.08. 05:20 keltezéssel, Pataki István írta:
>>
>>      
>>> Ok, akkor ezt még körül kell járnom. Magánhasználatra sem legális? Erről
>>>
>>>        
>> úgy tudom otthon használhatod, el kell olvasni a microchip oldalán
>>
>>
>>
>>
>>      
> -----------------------------------------
>            elektro[-flame|-etc]
>
>
>