[elektro] USB licensz?

[Bali Zoltan]

Hali!

Milyen OS környezet ?

Amikor nemrég PCI IO bővitő kártyát kerestem
a következőt találtam az alábbi linken.

A0009:     It is not possible to manually change IRQ setting of all PCI 
devices in any operating systems because the IRQ used by the device is 
assigned by the PCI system and cannot be changed. Usually the only way 
to change the IRQ of a PCI device is to move it to a different PCI slot. 
Each slot is usually assigned a different IRQ, although this is not 
always true. Each system may handle the assignment of IRQs differently.
Q0010:     Is it possible to remap the I/O addresses of MCS98xx 
Parallel/Serial ports to Legacy I/O address values?
A0010:     In order to be compatible with some legacy software, some 
users might need to remap the assigned I/O addresses of MCS98xx 
Parallel/Serial ports to Legacy (ISA type) I/O address (such as 378h, 
3F8h, etc.). It is possible on DOS and Windows 95/98/ME operating 
systems but impossible on Windows NT/2000/XP/Vista/7/8 operating systems 
because the Remap I/O Address feature is only supported on DOS and 
Windows 95/98/ME operating systems but is not supported on Windows 
NT/2000/XP/Vista/7/8 operating systems. As the newer Windows systems 
maintain a much tighter control over the I/O devices and prevent any 
Re-Mapping I/O Address operation at device driver level. When the 
Re-Mapping I/O Address is not permitted, the device must use the I/O 
Addresses assigned by the PCI system at Boot-Up. If the software 
application expects the Parallel/Serial ports to use Legacy I/O address 
resources, it will not be possible to make it work with the 
Parallel/Serial ports of PCI based devices on Windows 
NT/2000/XP/Vista/7/8 platforms. On DOS platform, MCS98xx can remap the 
I/O addresses of the Parallel/Serial ports to desired values by running 
MCS98xx DOS utility. However, on Windows 95/98/ME platforms, you can 
only remap the I/O addresses of the Serial ports (but not Parallel port).

<http://www.asix.com.tw/faq.php?op=faqdetail&PItemID=126&FaqNoID=#517>

Tehát, ha jól olvasom, max. DOS-nál lehet remap-elni az LPT-t,
ezeknél az MCS chip-eknél.

Üdv.  Zoli


2013. 03. 08. 18:26 keltezéssel, Pipi írta:
> 2013.03.08. 05:20 keltezéssel, Pataki István írta:
>    
>> Ok, akkor ezt még körül kell járnom. Magánhasználatra sem legális? Erről
>>      
> úgy tudom otthon használhatod, el kell olvasni a microchip oldalán
>
>
>
>