[elektro] OT: Canon I320 hiba

[Pipi]

Bali Zoltan írta:
> Sziasztok !
> 
> A fenti nyomtató  elvileg ezt villogja:
> "Waste ink full or platen waste ink full error"
> A fejet sem hozza a csere pozicióba.
> 
> Mit lehet ezzel kezdeni ? Lehet valamit takaritani ?
> A manual azt mondja "Replace the printer as it has failed".
> Még nem szedtem szét.
> 
> Köszi
hali!
nem a printert kell replacelni, hanem a benne lévő tinta gyűjtő filcet (aztán lehet hogy bírja még, félig sincs)
ellenőrizni kell ha nem akarsz tintafoltot az asztalodon, utána szervízprogival le kell törölni a hibaüzit
ennyi infóm van még, nem próbáltam...,
valamelyik canonnál ez a gombot nyomkodom dolog az első konnektorból kihúzásig(áramszünetig) működött,
  utána újra kellett jáccani, de valamelyik progival helyre lehetett hozni

  Re: Canon i350 waste tank full by PrintX (7/29/04 3:48 PM) reply + / -
Try this it is generally for the i320 i255 but it should do the trick.

i320 waste ink counter reset.
1. Turn off the printer.
2. Press and hold the POWER button, turn on the printer.
3. The indicator should be green.
3. Press and release the RESUME button , the indicator should be orange.
4. Press and release the RESUME button again, the indicator should be green.
5. Release both buttons.
6.Connect the printer to PC.
7.Open General Tool software,choose ˇ°USB PORTˇ±.
8.Choose ˇ°SET DESTINATION 1 ˇ±,OK!

You can download the software at: http://www.it0577.com/yezmao/i320.exe

  --------------------------------
  here are the steps to make it a permanent reset. please follow these instructions carefully as you might end up doing the wrong thing and end up not resetting your printer.

Using the I320 Service Tool
1. setup your pc and install windows 98/98SE/ME. this is required to ensure that the i320 service tool will run.
2. after installation (which includes all drivers), install the appropriate printer driver for the printer. you can download it from canon's driver download site.
3. run the i320 service tool and follow the steps below.

EEPROM reset / Destination setting
4. install the print head, and while holding down the POWER button, plug in the AC cable (the green lamp lights up.)
5. while still holding down the POWER button, press the RESUME button twice and release the POWER button to enter the Service Mode (each press of the RESUME button changes the LED color: the LED 
lights in orange the first time, and in green at the second time.)
6. connect the printer to the computer, select "USB PORT" using the i320 service tool.
7. Destination setting
-other than Japan: select "1" in "SET DESTINATION"
-Japan: select "2" in "SET DESTINATION"
EEPROM reset
EEPROM is reset at the same time when the destination is set.

you can download the i320 Service Tool from this address:
http://www.it0577.com/yezmao/i320.exe

note: the "I/F dll can not be loaded" error means that you were running the i320 service tool without the printer's drivers installed on your computer. make sure that you have installed the printer 
driver first before attempting to reset the printer.






-- 
Pipi
http://www.puzsar.hu