[elektro] PIC32 ICSP lábak

[flaist]

Szia!

Itt tényleg le van írva.
De hát ennyit olvasni, egy ICD láb bekötésért.

Viszont itt szemet szúrt az ENHANCED ICSP.
Használta már valaki, mi kell hozzá?

Köszi, üdv.  FI.



-----Original Message-----
From: elektro-bounces at tesla.hu [mailto:elektro-bounces at tesla.hu] On Behalf
Of Pataki István
Sent: Thursday, February 06, 2014 11:14 AM
To: elektro at tesla.hu
Subject: Re: [elektro] PIC32 ICSP lábak

http://ww1.microchip.com/downloads/en/DeviceDoc/61129F.pdf
PIC32MX Family Reference Manual
Section 33. Programming and Diagnostics

DS61129F-page 33-4
"Control of the programming process is achieved by manipulating PGC and
MCLR. 
Entry into and exit from Programming mode involves applying (or removing)
voltage to MCLR while supplying a code sequence to PGD and a clock to PGC.
Any one of the PGCx/PGDx pairs can be used to enter programming."

DS61129F-page 33-5
"ICSP also provides a hardware channel for the In-Circuit Debugger (ICD)"
"In contrast with programming, only one of the ICSP ports may be used for
ICD. 
If more than one ICSP port is implemented a Configuration bit determines
which port is available. Depending on the particular PIC32MX family of
device, there may be two or more ICSP ports that can be selected for this
function. The active ICSP debugger port is selected by the ICESEL
Configuration bit(s). For information on specific devices, refer to the
appropriate device data sheet."

http://ww1.microchip.com/downloads/en/DeviceDoc/61145L.pdf?from=rss
PIC32 Flash Programming Specification
DS61145L-page 21

(Arra figyelj, hogy a DSnnnnnX verziója (X) melyik, mert elég nagy eltérések
lehetnek!)