[elektro] RPI rádió 1043

Stonie laca256 at gmail.com
Wed Dec 25 13:55:09 CET 2013


persze lehet j-taggal is, de ha elindul a U-Boot, akkor tftp-nek is mennie
kell


On Wed, Dec 25, 2013 at 11:50 AM, Fekete Róbert <frobi at harden.hu> wrote:

> no eljutottam odáig hogy soroport már van
> ezt köhögi :
>
>
>
> U-Boot 1.1.4 (Nov 17 2009 - 11:56:26)
>
> AP83 (ar9100) U-boot 0.0.11
> DRAM:
> sri
> 32 MB
> id read 0x100000ff
> flash size 8MB, sector count = 128
> Flash:  8 MB
> Using default environment
>
> In:    serial
> Out:   serial
> Err:   serial
> Net:   ag7100_enet_initialize...
> No valid address in Flash. Using fixed address
> : cfg1 0xf cfg2 0x7114
> eth0: 00:03:7f:09:0b:ad
> eth0 up
> eth0
> Autobooting in 1 seconds## Booting image at bf020000 ...
>     Uncompressing Kernel Image ... OK
>
> Starting kernel ...
>
> Linux version 2.6.32.27 (jow at nd-build-02.linux-appliance.net) (gcc
> version 4.3.3 (GCC) ) #5 Wed Dec 21 01:59:33 CET 2011
> bootconsole [early0] enabled
> CPU revision is: 00019374 (MIPS 24Kc)
> Atheros AR9132 rev 2, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz
> Determined physical RAM map:
>   memory: 02000000 @ 00000000 (usable)
> Initrd not found or empty - disabling initrd
> Zone PFN ranges:
>    Normal   0x00000000 -> 0x00002000
> Movable zone start PFN for each node
> early_node_map[1] active PFN ranges
>      0: 0x00000000 -> 0x00002000
> Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
> Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd
> console=ttyS0,115200 board=TL-WR1043ND
> PID hash table entries: 128 (order: -3, 512 bytes)
> Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
> Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
> Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
> Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
> Writing ErrCtl register=00000000
> Readback ErrCtl register=00000000
> Memory: 29276k/32768k available (2126k kernel code, 3492k reserved, 423k
> data, 152k init, 0k highmem)
> SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
> Hierarchical RCU implementation.
> NR_IRQS:56
> Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
> Mount-cache hash table entries: 512
> NET: Registered protocol family 16
> MIPS: machine is TP-LINK TL-WR1043ND
> bio: create slab <bio-0> at 0
> Switching to clocksource MIPS
> NET: Registered protocol family 2
> IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
> TCP established hash table entries: 1024 (order: 1, 8192 bytes)
> TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
> TCP: Hash tables configured (established 1024 bind 1024)
> TCP reno registered
> NET: Registered protocol family 1
> squashfs: version 4.0 (2009/01/31) Phillip Lougher
> Registering mini_fo version $Id$
> JFFS2 version 2.2. (NAND) (SUMMARY)  Â(c) 2001-2006 Red Hat, Inc.
> yaffs Dec 10 2011 18:14:12 Installing.
> msgmni has been set to 57
> io scheduler noop registered
> io scheduler deadline registered (default)
> Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
> serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
> console [ttyS0] enabled, bootconsole disabled
> console [ttyS0] enabled, bootconsole disabled
> Atheros AR71xx SPI Controller driver version 0.2.4
> m25p80 spi0.0: unrecognized JEDEC id 1c3017
> Realtek RTL8366RB ethernet switch driver version 0.2.3
> rtl8366rb rtl8366rb: using GPIO pins 18 (SDA) and 19 (SCK)
> rtl8366rb rtl8366rb: RTL5937 ver. 3 chip found
> rtl8366rb: probed
> eth0: Atheros AG71xx at 0xb9000000, irq 4
> Atheros AR71xx hardware watchdog driver version 0.1.0
> TCP westwood registered
> NET: Registered protocol family 17
> 802.1Q VLAN Support v1.8 Ben Greear <greearb at candelatech.com>
> All bugs added by David S. Miller <davem at redhat.com>
> VFS: Cannot open root device "<NULL>" or unknown-block(0,0)
> Please append a correct "root=" boot option; here are the available
> partitions:
> Kernel panic - not syncing: VFS: Unable to mount root fs on
> unknown-block(0,0)
>
>
>
> mivel nincs prompt a végén, asszem j-tag marad a helyrerázáshoz
> így veszett
>
> 2013-12-24 01:22 keltezéssel, Pipi írta:
> > 2013.12.23. 23:42 keltezéssel, Fekete Róbert írta:
> >> nem próbáltam, majd holnap ma már fű se nő :)
> >> mondjuk soros porton nem tudom hogy kellene updatelni...
> >>
> >
> >>>> 2013-12-23 22:55 keltezéssel, Pipi írta:
> >>>>> Hali!
> >>>>> ezeket láttad?
> >>>>> http://wiki.openwrt.org/toh/start#tp-link
> >>>>> http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd
> > OEM installation using the TFTP and RS232 method
> >
> >
> >
> >
>
> -----------------------------------------
>           elektro[-flame|-etc]


More information about the Elektro mailing list