PIC device ID -&- asm kerdesek

[b.joe]

On Sat, 5 Nov 2005 19:04:45 +0100
Balla Zoltán <vega55 at freeweb.hu> wrote:

> Tudtommal a hex file-ban csak a program, eeprom, config, User ID mezok hasznalatosak(mar ahol), ezeket lehet max 
> kiolvasni belole, mig a DevID magabol az eszkozbol(PIC) olvasodna ki osszehasonlitas celjabol a programozonak 
> megadottal, egyezesre...

Nem tudok megadni PIC tipust (csak parancssor van)

picprog [/h] [/log] [/info] [/list] [/init2] [/standby] [/read] [/continue] [/compare] [/noF84] [lpt1|lpt2] [/w:FILENAME] 

Parameter definition:

*****************************************************************************************

/h		help 	
/log		write output to picprog.log, forces /info 	
/info		show full programming information 	
/list		list of supported PIC 	
/init2		use /MCLR before Vpp power-up mode 	
/standby	loop program 	
/continue	continue programming also while errors occur 	
/noF84		blocks PIC16F84 mode 	
/lptX		definition of parallel port 	
/read		data transfer from pic to file, reverses /w: command 	
/compare	data comparison of pic and file, overrides /w: command 	
/w:		erase and write PIC, uses hex-file, extension will be ignored and set to .hex
***************************************************************************************

Ezt a hibauzenetet kapom:

fullinfo mode active
PIC16F84 mode blocked
Speedfactor: 1203 
using LPT 1 at: &h0378
using file: pic.hex
 1 . ID Location: 1111B
 2 . ID Location: 1111B
 3 . ID Location: 1111B
 4 . ID Location: 1111B
device ID & rev: 11111111111111B
device ID:  1111111111B
device not known, stopping, since PIC16F84 blocked

Nem minden PIC ugyanazt a protokolt, idozitest hasznalja. (vagy igen?)
Hogy tudja kiolvasni, hogy milyen IC van a programozoban?

-- 
UHU 1.2
udv.:
jozsi