Suzuki adatcsati... ami valoszinuleg nem is ALDL...

[Rozsahegyi Bela]

> > > Van FreeDiag, de ez linux...
> Hehe. nekem linux van. El tudnad kuldeni ezt a progit? Koszi!

Sourceforgen fent lakik freediag neven :)
A Makefile-je kisebb atirasra szorult, mindenkeppen a jo kis bugos
2.96-os gcc-hez ragaszkodott, de meggyozheto volt, hogy nem gondolja komolyan :)

elindottam, irkalt sokfelet, csak egy auto hianyzott rola :)
 Illetve van egy diag_test nevu resze is, ami ir erdeksebbet csak igy
uresen, hardware nelkul, a soros portot: 10400 bits 8 stopbits 1 parity 3
szerette volna allitani :)
Ismeros valakinek ez barmi mas teruletrol?

A doksija szerint 2 lenyegsebb info:
This Scantool talks only SAEJ1979 (ODB II) protocol on ISO9141 and
ISO14230 interfaces (K line interfaces).

It is configured for Silicon Engines ISO 9141 interface, which will work
with "Jeff's" Interface and other VAG-COM compatable interfaces [see the
opendiag list on yahoogroups]

It also can use the Multiplex Engineering interface, note that on some PCs
the serial ports are out of spec and can not drive this interface. The
interface supports J1850 VPW & PWM interfaces but this software does not
yet.


Hardware Interfaces: -

        The software is configured to use a RS232->ISO9141 adapter such
        as a VAG-COM compatable (Andy Whittaker's interface, Jeffs
interface, Silicon Engines interface) by default.

        To use the multiplex engineering interface, order an interface from
        multiplex engineering with an ID of 0x38 - alternatively recompile
        the code changing the INTERFACE_ADDRESS definition in diag_l0_me.c
        Then, after starting Scantool, type "set interface met16"

        The multiplex engineering interface takes it's power from the PC's
        serial port - if your PC is out of spec and does not supply enough
        power then you will get checksum errors and a message will be printed.





		RB