Balun???
Greczi Laszlo
lgreczi at scinetwork.hu
Wed Nov 7 11:55:56 CET 2001
Dukai Zoltan wrote:
> Ooo..... ezt megprobalom megemeszteni... :o)
> Tehat a kebelt sjat tengelye korul kellene elcsavargatni????
En ugy gondolom, a lapos szalagkabelt (60ohmos, nem a szokasos
tv-szalagkabel) egy (mondjuk 5mm atmeroju) rudra tekered "menet menet
melle"...
Azert a leiras eleg nagyvonaluan kezeli a dolgot:
"..by winding a 10 to 15 cm length of
UHF flat cable (60 ? impedance; the
small difference with 75? is not important)
into a coil. The way that this
balun works is easy to explain. It acts as
a choke for unbalanced currents, while
allowing balanced currents to pass
unhindered. With this balun, an open
dipole can be used as the driven element
in the GSM Yagi antenna. Note
that the balun is not absolutely necessary,
but it allows the full gain of the
antenna to be realized."
Vagyis 10-15cm; 60 vagy 75 ohm nem nagyon fontos; sot, az egesz balun
nem feltetlenul szukseges; az ajanlott RG-58U kabel pedig tudtommal 50
ohmos. (az RG-59 a 75 ohmos)
Ha ennyire nem kritikus, lehet, hogy a 300 ohmos tv szalagkabel is jo
(bar az gondolom meretben nagyobb)
Lehet kapni antennasboltokban keszen is TV balunt, szerintem az is jo
(tv sav teteje 860Mhz korul van), mas kerdes, hogy hogyan
csatlakoztatod...
vagy lehet kis koaxkabelhurkot is kesziteni, de annak elhelyezese
(viz/paramentesen) is tervezgetest igenyel...
Ha hulyeseget beszeltem, majd az rf technikaban jartasabbak
helyretesznek :-)
--
Greczi Laszlo E-mail: mailto:lgreczi at scinetwork.hu
More information about the Elektro
mailing list